Enabling Acl Logging - Avaya P580 User Manual Addendum

Enabling ACL Logging

Web Agent
Procedure
Part No. 610-0211-094
Forwarding information:
The priority of the packet if the ACL assigns it a priority
—
and forwards it.
Forward with no change in priority if the ACL
—
forwards the packet without changing its priority.
FILTER if the ACL blocks the packet.
—
To avoid excessive consumption of the switch resources, ACL
matches are logged for slow path traffic at specific time intervals.
You can set the interval at which the matches are logged. The
default setting is two seconds.
ACL matches are not logged for FIRE path or FORE path traffic. For
more information about the slow path and FIRE and FORE paths,
see "Routing Overview" in Chapter 1, "Introduction," of the Avaya
P550R, P580, P880, and P882 Multiservice Switch User Guide.
This section includes procedures for the following tasks:
Enabling ACL Logging
Setting a Logging Interval
To enable ACL logging by using the Web Agent:
1. In the navigation pane, expand the Routing > IP >
Configuration folders, and then click Access Lists.
The IP Access List Web page is displayed in the content pane.
See Figure 1.
Doc. No. 650-100-701
on page 5
on page 7
December 2, 2002 5