Installing The Manifold; Installing The Harness - Air Lift WirelessONE 25870 Installation Manual

WirelessONE

INSTALLING THE MANIFOLD

IF THE USER INSTALLS THE MANIFOLD OR COMPRESSOR IN THE CAB OF THE
WARNING
VEHICLE IN EXTREME WEATHER CLIMATES, DO NOT USE ANY ANTI-FREEZE
PRODUCT IN THE SYSTEM AS EXHAUST FUMES CAN BE TOXIC. CARE MUST BE
TAKEN WHEN USING THIS PRODUCT! IT IS RECOMMENDED THAT THIS PRODUCT'S
MSDS SHEET BE REVIEWED BEFORE USE! THIS CAN BE OBTAINED WHERE YOU
PURCHASE THIS PRODUCT.
1. Select a rigid mounting location for the manifold (B) on the vehicles frame or cross
2. Use mounting bracket 11068 (R) to secure to the rigid mounting surface with a 17173

INSTALLING THE HARNESS

•
One of the self tapping screws will be used as an electrical ground for the compressor
and manifold ring terminals.
•
Another of the self tapping screws can be used to mount the compressor relay.
member that shields the manifold from the elements and heat sources (fig. 4 & 5).
fastener (S). The manifold should not be the lowest point in the pneumatic system.
fig. 4
Compressor
Ground
B
Ignition Wire
fig. 6
Power Wire
Relay
fig. 5
Fuse Adapter
Fuse Box
In Line
15 amp Fuse
Manifold
Manifold
Electrical
Connector
Air Springs
(previously installed)