Installing The Wirelessone System; Installing The Compressor; Installing The Manifold - Air Lift WirelessONE 25870 Installation Manual

Installing the WirelessONE System

INSTALLING THE COMPRESSOR

1 .
NOTE
The electrical harness will force the compressor to be within 24" of the manifold in order to
make electrical connections.
2.

INSTALLING THE MANIFOLD

1 .
2.
6
Select a rigid mounting location for the compressor on the vehicles frame or cross
member (fig. 3) that shields the compressor from the elements and heat sources.
fig. 3
Frame
Use the supplied self tapping fasteners to fasten the compressor to the frame or cross
member .
•
One of the self tapping screws will be used as an electrical ground for the compressor
and manifold ring terminals .
• Another of the self tapping screws can be used to mount the compressor relay.
Select a rigid mounting location for the manifold (B) on the vehicles frame or cross
member that shields the manifold from the elements and heat sources (fig. 4 & 5).
Use mounting bracket 11068 (R) to secure to the rigid mounting surface with a 17173
fastener (S). The manifold should not be the lowest point in the pneumatic system.
fig. 4
Self-tapping
Screws
Compressor
B
WirelessONE
Compressor Ground
Harness Ground
Relay
fig. 5
MN-751