Pair The Manifold To The Wireless Controller; Units; Troubleshoot - Air Lift WirelessONE 25870 User Manual

PAIR THE MANIFOLD
TO THE WIRELESS
CONTROLLER
The manifold will enter pairing mode for
three minutes after the fuse is installed.
Once a device is paired, it will
automatically connect if no other device
is already connected. The wireless
controller will go into sleep mode after
40 seconds, at which time it will
disconnect from the system.
NOTE
1. To initiate pairing mode, remove the
fuse, wait five seconds and reinstall.
2. Press any button to wake up the
controller. It will automatically go to
the pairing screen if it is not already
paired with a manifold. Use the up
and down arrow buttons to navigate
the pairing menu. Select the device
that matches the manifold serial
number (Figs. B.2 & B.3).
3. Use the up and down arrows to
6
The wireless controller comes
with batteries installed. To
operate the device, slowly
pull the tab out of the battery
compartment.
choose the manifold. Press • (P1)
to begin the pairing process.
4. The device will indicate "pairing"
when it is connecting to a device.
There is no Bluetooth password.
5. Once complete, the controller will
either indicate "Pairing successful,"
which means the devices are paired,
or "Pairing unsuccessful," which will
require the user to pull and reinstall
the fuse and try again. Once the
wireless controller is connected to the
manifold, it will automatically connect
each time the manifold is active and
the controller is woken up.
NOTE
To enter the menu, press the
inflate and deflate buttons
simultaneously (Fig. B.1).

UNITS

Choose Units from the menu to change
between PSI and BAR (Fig. B.4). The
factory default is PSI.

TROUBLESHOOT

Choose Troubleshoot from the menu to
see system error messages. For more
information about error messages, see
D. Troubleshooting.
WirelessONE User Guide
fig. B.2
fig. B.3
fig. B.4