Recommended Compressor Locations; Installing The Compressor - Air Lift WirelessONE 25870 Installation Manual

Installing the WirelessONE System

RECOMMENDED COMPRESSOR LOCATIONS

Disclaimer: If you choose to mount the compressor outside the vehicle please keep in
mind the compressor body must be shielded from direct splash and the intake should be
snorkeled inside the vehicle. If the compressor does not include a remote mount air filter or
if mounting the compressor outside the vehicle, make sure to orient the compressor intake
filter so that all moisture can easily drain.
Please also remember . . .

INSTALLING THE COMPRESSOR

1. Select a rigid mounting location for the compressor on the vehicles frame or cross
NOTE
The electrical harness will force the compressor to be within 24" of the manifold in order to
make electrical connections.
2. Use the supplied self tapping fasteners to fasten the compressor to the frame or cross
LOCATE COMPRESSOR IN DRY, PROTECTED AREA ON VEHICLE.
DIRECT SPLASH OR EXCESSIVE MOISTURE CAN DAMAGE
THE COMPRESSOR AND CAUSE SYSTEM FAILURE.
• To avoid high heat environments
• To avoid mounting the compressor under the hood.
• To check to be sure the compressor harness #2 will reach the compressor and connect
to harness #1.
• The compressor can be mounted in any position — vertical, upside down, sideways,
etc. (please refer to the instruction manual).
member (fig. 3) that shields the compressor from the elements and heat sources.
fig. 3
Frame
member.
Important
Self-tapping
Screws
Compressor
WirelessONE
Compressor Ground
Harness Ground
Relay