How To Sync The Receiver To The Transmitter - Air Lift WirelessONE 25870 Installation Manual

WirelessONE
Saving and Recalling Memory 2:
Saving and Recalling Memory 3:

HOW TO SYNC THE RECEIVER TO THE TRANSMITTER

(ONLY NEEDED WITH A REPLACEMENT TRANSMITTER)
1. Turn ignition on.
2. Locate the sync wire in the wire harness.
3. Strip ¼" of the insulation off the end of the wire.
4. Touch this wire to the self tapping screw that you have used for grounding your receiver
5. Disconnect power to the receiver.
6. Connect power to the receiver while grounding the sync input.
7. Listen for 3 clicks of the internal solenoid, then one click every second.
Recalling Memory
• Initial press of any button will wake up display and not perform any function.
• Upon wake up the LCD will display the Desired pressure.
• Press the M2 button to set the M2 pressure as the desired pressure.
• Upon the press of the M2 button the display will display "M2".
• Once the button is released the display will display the new desired pressure and
transmit the desired pressure to the receiver.
Saving to Memory
• Press and hold the memory button for 5 seconds to set the desired pressure to
memory 2.
• While the M2 button is pressed the display will display "M2".
• Once the desired pressure is saved to M2 the display will flash the backlight three
times.
Recalling Memory
• Initial press of any button will wake up display and not perform any function.
• Upon wake up the LCD will display the Desired pressure.
• Press the M1 & M2 buttons to set the M3 pressure as the desired pressure.
• Upon the press of the M1 & M2 buttons the display will display "M3".
• Once the buttons are released the display will display the new desired pressure
Saving to Memory
• Press and hold M1 & M2 buttons for 5 seconds to set the desired pressure to
memory 3.
• While the M1 & M2 buttons is pressed the display will display "M3".
• Once the desired pressure is saved to M3 the display will flash the backlight three
times.
• It will be the yellow wire that is looped with heat shrink around it.
/ compressor.
• Unplug the connector on the top.
• This will indicate that you are now in the "sync mode".
• Sync mode will last for 30 seconds total.
• Within the 30 seconds press any button on the transmitter to send a message to
the receiver.