How To Remove And Install The Batteries; Fcc Information To User - Air Lift WirelessONE 25870 Installation Manual

Key fob activated compressor system

Hide thumbs Also See for WirelessONE 25870:

Table of Contents

• Once the receiver has received a message it will sync with that transmitter and stop

clicking the solenoid in 1 second intervals.

HOW TO REMOVE AND INSTALL THE BATTERIES

To remove the two CR2032 batteries use a small flat screw driver to seperate the two

halves of the key fob by prying at the internal clip locations shown in fig. 8.

Stack the two CR2032 batteries Positive to Negative inside the rear cover.

Clip the front cover and circuit board into the rear cover.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT

TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL

INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE

RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.

SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THIS

EQUIPMENT.

FCC ID: YHT-BRM920AJM1017

WirelessONE

Table of Contents