Replacing The Sensor-Thermistor - Samsung NX583G0VBSR Service Manual

3. Disassembly and Reassembly

3-10 Replacing the Sensor-Thermistor

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing . Check all gas lines and fittings for leaks before operating
the range . Replace all panels before operating range . Failure to do so can result in death or personal
injury from explosion, fire, or asphyxiation .
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be
present, and you can cut yourself if you are not careful .
Parts
Upper Oven
Burner
Shield and
Upper Oven SENSOR THERMISTER
Burner
This document can not be used without Samsung's authorization.
Explanation Photo
CONNECTOR
22
Explanation
1. Turn off the electrical supply going
to the range .
2. Shut off the gas shut-off valve in
the gas supply line to the range .
3. Open the oven door and remove
the racks from inside the oven .
4. Disconnect connector of the
sensor thermister to the rear of the
range .
5. The oven sensor thermister is in
the upper left-hand corner of the
oven cavity . Remove 2 screws and
carefully pull the sensor wire leads
until the wire connectors appear .
6. Reverse the order to install the
oven temperature sensor .
NOTE: If you can't access the wire
connectors from inside the
oven, remove the rear cover
panel . Mark and disconnect
the two wires going to the oven
sensor thermister .