Removing The Chassis Manifold Panel, Knob, Switch Ignition - Samsung NX583G0VBSR Service Manual

3. Disassembly and Reassembly

3-4 Removing the Chassis Manifold Panel, Knob, Switch Ignition

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing . Check all gas lines and fittings for leaks before operating
the range . Replace all panels before operating range . Failure to do so can result in death or personal
injury from explosion, fire, or asphyxiation .
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be
present, and you can cut yourself if you are not careful .
Parts
Knob
Chassis Manifold
Panel
Switch Ignition
This document can not be used without Samsung's authorization.
Explanation Photo
Pull the control knob straight off
Screws from the bottom
Connector
15
1. Turn off the electrical supply
going to the range .
2. Shut off the gas shut-off valve
in the gas supply line to the
range .
3. Open the door or Remove it .
4. Pull burner control knobs
straight off to remove them
from the valve shafts .
5. Remove 2 screws from the top,
2 screws from the front and 4
screws from the bottom of the
chassis manifold panel .
6. Remove the chassis manifold
panel from the front of the
range .
7. Place a finger behind each side
of the switch ignition and pull
it straight out to release it from
Switch ignition
the control shaft . Repeat for
each switch .
8. Disconnect the wires at the
connectors .
Explanation