Replacing The Burner Bake - Samsung NX583G0VBSR Service Manual

3. Disassembly and Reassembly

3-18 Replacing the Burner Bake

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing . Check all gas lines and fittings for leaks before operating
the range . Replace all panels before operating range . Failure to do so can result in death or personal
injury from explosion, fire, or asphyxiation .
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be
present, and you can cut yourself if you are not careful .
Parts
Burner Bake
This document can not be used without Samsung's authorization.
Explanation Photo
CONNECTOR
CAVITY FLOOR
BRACKET
BAKE SPREADER
30
Explanation
1. Turn off the electrical supply going
to the range .
2. Shut off the gas shut-off valve in
the gas supply line to the range .
3. Open the oven door and remove
the racks from inside the oven .
4. Pull on the wires or the connector
until the wire connector appears
from the back wall of the warming
drawer opening .
5. Disconnect the connector of HSI of
the burner bake .
6. Remove the two screws from the
back of the cavity floor . Lift back to
clear the front edge and lift out the
cavity floor .
7. Remove 2 screws from the front of
the bracket bake-spreader .
8. Lift front the bracket bake-
spreader and lift out the bracket-
bake spreader .
9. Lift up the burner bake from the
holder-bake burner on the bottom
of the drawer .