Replacing The Hot Surface Ignitor (Hsi) Of The Burner Bake, Nozzle Bake-Burner, And Holder Bake-Burner - Samsung NX583G0VBSR Service Manual

3. Disassembly and Reassembly
3-19 Replacing the HOT SURFACE IGNITOR (HSI) of the BURNER BAKE,
NOZZLE BAKE-BURNER, and HOLDER BAKE-BURNER
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing . Check all gas lines and fittings for leaks before operating
the range . Replace all panels before operating range . Failure to do so can result in death or personal
injury from explosion, fire, or asphyxiation .
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be
present, and you can cut yourself if you are not careful .
Parts
Hot Surface
Ignitor (HSI)
Nozzle Bake
-Burner
Holder
Bake-Burner
This document can not be used without Samsung's authorization.
Explanation Photo
HSI
NOZZLE
HOLDER
NOTE .
31
Explanation
1. To replace the HSI of the
burner bake, Remove 2 screws
assembled to HSI
1. To replace the nozzle bake-burner,
Remove the gas orifice with a
9/32-inch socket wrench .
1 . To remove the holder-bake burner,
Remove 2 screws supporting the
holder-bake burner to the rear of
the oven .
2 . When the service is complete,
reverse the order to install Burner
bake, HSI, Nozzle, Holder bake-
burner .
NOTE: The oven burner flames can
be adjusted by loosening the
locking screw and opening or
closing the air shutter at the
base of the oven burner .