Replacing The Sensor-Thermistor - Samsung NX58H5600SS/AA Service Manual

3. Disassembly and Reassembly

3-9 Replacing the Sensor-Thermistor

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range. Replace all panels before operating the range. Failure to do
so can result in death or electrical shock.
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
operating the range. Replace all panels before operating the range. Failure to do so can result in death or
CAUTION
When you work on the gas range, be careful when handling sheet metal parts. Sharp edges may be
present, and you can cut yourself if you are not careful.
Parts
Upper Oven
Burner
Shield and
Upper Oven
Burner
SENSOR THERMISTER
CONNECTOR
1. Turn off the electrical supply going
to the range.
2. Shut off the gas shut-off valve in
the gas supply line to the range.
3. Open the oven door and remove
the racks from inside the oven.
4. Disconnect the sensor thermister
connector to the rear of the range.
5. The oven sensor thermister is in
the upper left-hand corner of the
oven cavity. Remove 2 screws and
carefully pull the sensor wire leads
until the wire connectors appear.
6. Reverse the order to install the
oven temperature sensor.
NOTE: If you can't access the wire
21
connectors from inside the
oven, remove the rear cover
panel. Mark and disconnect
the two wires going to the oven
sensor thermister.