Table of Contents
Advertisement
8800 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
2
Indicator Variants
Depending on function and option ordered,
indicators are provided in the following
variations, these instructions detail how to install
with cylinder, however other variations follow
similar instructions. (Figure 1)
Contact factory for any questions.
3
Lock Set Configuration
To re-hand lock, see instructions on lock body.
4
Rehanding Indicator (If required)
Verify hand and bevel of door. (Figure 2)
LH
Left Hand
Hinges Left
Open Inward
Note:
Stand on outside of locked door when determining door hand.
Next, verify inside and/or outside indicators are handed correctly,
using Spindle Cam Position chart. (Figure 3) If they are handed
correctly, skip to Step 5 "Prepare Door".
If they are not handed correctly:
1.
Remove indicator back plate by pulling out from top slot, then
remove spindle cam from assembly. (Figure 4)
2.
Position spindle cam in correct direction for door hand.
(Figure 3)
Important:
•
For thumbturn indicators, make sure thumbturn is positioned
in the 12 o'clock direction as shown. (Figure 5)
3.
Slide spindle cam post into correct slot of display slide.
(Figure 4)
4.
Re-seat back plate into original position.
5.
Return indicator to the vacant/unlocked position for
installation.
For technical support contact Yale
®
at 800.438.1951 x5033 or support@yalelocks.com
Copyright ©2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited
LHRB
RH
Left Hand
Right Hand
Reverse Bevel
Hinges Right
Hinges Left
Open Inward
Open Outward
Figure 1
Cylinder - For
Thumbturn -
installation
For installation
on inside or
on inside of
outside of door.
Spindle Cam Position for Locks with Deadbolt
Figure 2
Outside Indicator
RHRB
Inside Indicator
Right Hand
Reverse Bevel
Hinges Right
Spindle Cam Position for Locks without Deadbolt
Open Outward
(*does not include 8864 function)
Inside Indicator
Outside Indicator
Figure 4
3
No input / blank -
Coin Turn - For
For installation on
installation
inside or outside
on outside of
of door.
door.
door.
(*includes 8864 function)
Door Hand RH/RHRB
Inside Indicator
Door Hand LH/LHRB
Outside Indicator
Door Hand RH/RHRB
Outside Indicator
Door Hand LH/LHRB
Inside Indicator
Thumbturn
Position
Backing
Plate
Spindle cam
80-8800-0017-000 12/20
Figure 3
Figure 5
Advertisement
Table of Contents
