Table of Contents
Advertisement
10 Factory Reset the Tuner Genius XL
The configuration of the Tuner Genius XL can be reset to the "factory defaults" using the following procedure:
Turn the tuner off using the power switch on the back panel.
Press and hold the BYPASS/OPERATE front panel button.
Turn the tuner ON
Continue holding the BYPASS/OPERATE button until the "Config Reset" message appears on the front
panel.
Release the BYPASS/OPERATE button.
Start the Tuner Genius XL Windows Utility and connect to the tuner.
Set all configuration options as desired and then click SAVE. If you do not click SAVE, the new settings
will not be retained, and you will have to rerun the reset procedure.
11 Alarms, Warnings and Messages
If the tuner detects an operational error, a message is displayed on the main display and on the Windows
Utility, as shown below:
11.1 Alarms
When an alarm is raised, the tuner bypasses to protect itself from damage. The alarm is cleared when the PTT
is released.
Alarm
FREQUENCY OUT OF RANGE
WRONG BAND
HIGH POWER
> 10:1 SWR
Warnings
11.2
The following are warnings.
Warning
LOW DRIVE
PTT UNKEY
Messages
11.3
The following are messages.
Copyright 2021 FlexRadio. All Rights Reserved.
Description
Band data not detected. Check your band data settings/connections/sources.
Lorem ipsum
Drive power is too high to create a tuning solution
Antenna SWR is above the maximum that can be automatically tuned.
However, you may achieve a match for SWR > 10:1 by using the manual
tuning controls.
Description
Lorem ipsum
Lorem ipsum
Page 64 of 72
7 June 2021(FW:0.9.12, Utility: 0.9.12)
Advertisement
Table of Contents
