Tuner Genius Xl Setup, Configuration, And Testing; Unpacking And Setup; 1X3 Switch Model; So2R Switch Model - FlexRadio Systems Tuner Genius XL User Manual

6 Tuner Genius XL Setup, Configuration, and Testing

6.1 Unpacking and Setup

The following accessories and materials are included with your Tuner Genius XL tuner. Carefully remove the
tuner from its shipping container, unpack, and identify the items listed below:

One (1) Tuner Genius

One (1) 2m (6 ft) DC power cord with connector and pigtails

One (1) 2m (6 ft) Ethernet cable

One (1) Tuner Genius XL Quick Start Guide
In addition to the above, the following are required for the initial setup of the tuner:

HF or 6‐meter transceiver and antenna system

Suitable coax jumper cables for interconnection of the transceiver and tuner

Windows™ PC with an ethernet connection, connected to a local area network (LAN).
Place your Tuner Genius XL on a flat, stable surface. Ensure the tuner has at least 30cm (12 inches) of open
space in front and back to ensure adequate cooling. Then, follow these steps and refer to the following
diagrams to connect your Tuner Genius XL. For connections to non‐FlexRadio products, please see section 6.3,
Advanced Configuration.

6.1.1 1x3 Switch Model


Connect the transceiver antenna output to the Port A TX socket on the tuner with a suitable 50‐ohm
coax jumper cable.

Connect an antenna to the ANT 1 antenna socket.

6.1.2 SO2R Switch Model


Connect the transceiver antenna output to the Port A TX socket on the tuner with a suitable 50‐ohm
coax jumper cable.

Connect an antenna to the PORT A ANTENNA socket.

6.1.3 All Models


Connect the supplied Ethernet cable from the RJ45 socket on the tuner's back panel to an appropriate
1
switch port on your LAN.

Apply the DC power cord to the DC power input on the tuner's back panel. Connect the other end of
the power cord to a suitable 12VDC to 15 VDC power source. Be careful to observe correct polarity.

Turn the tuner on using the power switch on the back panel.
1
Most home routers contain integral switches. While the use of a separate switch for your ham equipment is strongly
encouraged, it is not a requirement. A LAN, however, is a requirement for configuring a TGXL.
2
A Windows™ PC must be present in the LAN to complete the configuration of the tuner.
Copyright 2021 FlexRadio. All Rights Reserved.
2
Page 15 of 72
7 June 2021(FW:0.9.12, Utility: 0.9.12)