6.2.3 Network Tab: Configuring the Network
The Tuner Genius XL is configured at the factory (or after a factory reset) to use DHCP IP addressing and will
automatically secure an IP Address appropriate for your network when it starts. This configuration should be
sufficient for most situations.
You can use the Network tab to assign a static IP Address, a static Network Mask, and a Gateway address. Static
IP addresses are desirable in some network configurations but require specific technical knowledge of the
network. Most configurations will not require these steps. If you don't need any of these options, please
proceed to the next section.
The network settings screen performs basic validation of the network settings. Note the red X next to an
incorrectly formatted subnet mask below.
If you are not familiar with the rules of setting or using static IP addresses but believe you need to configure
one, please submit a HelpDesk ticket for assistance.
When you have completed the network configuration, click Save to instruct the Tuner Genius XL to save the
configuration before performing the next step.
i – The tuner will reset when Save is pressed.
i – It is unnecessary to exit and restart the Tuner Genius XL Windows Utility after Save is pressed.
Page 22 of 72
Copyright 2021 FlexRadio. All Rights Reserved.
7 June 2021(FW:0.9.12, Utility: 0.9.12)