Basic Configuration; Connecting The Tuner Genius Xl Windows Utility Program - FlexRadio Systems Tuner Genius XL User Manual

6.2 Basic Configuration

Please complete the following steps to configure your Tuner Genius XL for use.

6.2.1 Connecting the Tuner Genius XL Windows Utility program

The Tuner Genius XL must be configured to work with the transceiver or transceivers that will drive it. The basic
configuration of the tuner is accomplished using the Tuner Genius XL Windows Utility program. Please see
section 14.1, Installing the Tuner Genius XL Windows Utility, for installation instructions.
Start the Tuner Genius XL Windows Utility program. It will automatically discover your Tuner Genius XL tuner,
and you should see something like this:
If you do not see your Tuner Genius XL in the Local devices list, please:

Double‐check your network connections and cables.

Ensure the Tuner Genius XL is powered on and an IP address is displayed on the front panel.

Check that the PC's firewall is configured to allow the Tuner Genius XL Windows Utility to communicate
over your network. The firewall is usually configured during the utility installation process.

Check that your PC and Tuner Genius XL share the same logical network. For example, the IP address of
your PC and the Tuner Genius XL should be similar, although not identical.

If you still have trouble, please submit a HelpDesk ticket for assistance.
Click on your tuner to select it, then click the Connect button.
Copyright 2021 FlexRadio. All Rights Reserved.
Page 19 of 72
7 June 2021(FW:0.9.12, Utility: 0.9.12)