Table of Contents
Advertisement
6.4 Antenna Genius Integration
The Tuner Genius XL will interface directly with an Antenna Genius (AG) 2x8 or 1x8 switch. Please refer to the
Antenna Genius User Guide available {here} for instructions on setup and configuring that device.
Integrating an Antenna Genius (AG) will unlock additional solution memories in the Tuner Genius XL and
automatically switch to an appropriate antenna for the frequency or band you are using.
6.4.1 Enable Integration
To enable AG integration, you must enable it, supply the network TCP/IP address and TCP port used by the
Antenna Genius on the Antenna Genius tab of the Tuner Genius XL Windows Utility. For example, in the case
below, the Antenna Genius is located at 192.168.0.190 and uses the default TCP port 9007 for communications.
Click [Save] to confirm and store the configuration.
Page 42 of 72
Copyright 2021 FlexRadio. All Rights Reserved.
7 June 2021(FW:0.9.12, Utility: 0.9.12)
Advertisement
Table of Contents
