User Interface Elements; Stby Button; Byp Button; Tune Button - FlexRadio Systems Tuner Genius XL User Manual

single decimal point less SWR may not provide much overall benefit.
RX Bypass
The Enable Bypass flags and Bypass Start/Stop frequencies set a "dead band" where the tuner does not engage
when PTT is asserted. When these flags are not set or on frequencies outside of the segment described by
Bypass Start and Bypass Sop, a tuning solution will always be applied.

8.4 User Interface Elements

8.4.1 STBY Button

The utility application provides a standby/bypass button. Clicking this button changes the tuner from Standby
mode to Operate or Bypass mode and back.

8.4.2 BYP Button

The utility application provides a bypass/operate button. Clicking this button changes the tuner from Bypass
mode to Operate mode and back.

8.4.3 TUNE Button

The utility application provides a TUNE button. A mouse click on this button starts a tuning cycle on the
frequency currently shown on the display.
Copyright 2021 FlexRadio. All Rights Reserved.
Page 61 of 72
7 June 2021(FW:0.9.12, Utility: 0.9.12)