Operating The Tuner Genius; Changing Modes; Bypass And Operate Modes; Standby Mode - FlexRadio Systems Tuner Genius XL User Manual

7 Operating the Tuner Genius XL

7.1 Changing Modes

The Tuner Genius XL provides three operational modes: Standby, Operate and Bypass. In Standby and Bypass
modes, the tuner does not modify incoming or outgoing signals. In Operate mode tuning solutions are applied
to the incoming and outgoing signals.

7.1.1 Bypass and Operate Modes

There are two ways the tuner can be toggled between Bypass and Operate modes.
1. By pressing the BYPASS/OPERATE button on the front panel of the tuner.
2. By changing the mode using software such as the utility program.
Front panel "Hard" button
i – When properly configured, a convenient method for switching between Standby, Operate, and Bypass
modes use software connected to the Tuner Genius XL over the LAN.
The front panel BYPASS/OPERATE button and the utility's BYP button toggle the operational state between
Bypass and Operate mode. The BYPASS LED on the Tuner front panel is on while the tuner is in Bypass mode.

7.1.2 Standby Mode

In Standby mode, the tuner disconnects from all antennas. As a result, tuning solutions that may be applied
while receiving are not applied. Standby can be entered by pressing and holding the BYPASS/OPERATE button
or using the STBY button in the utility program.
Copyright 2021 FlexRadio. All Rights Reserved.
Page 47 of 72
Tuner Genius XL Windows Utility Button
7 June 2021(FW:0.9.12, Utility: 0.9.12)