6.2.4 FlexRadio Tab: Configuring for a FLEX-6000 Series Transceiver.
To pair the tuner for use with a FLEX‐6000 Series transceiver, turn the radio on, then click on the FlexRadio tab
in the Tuner Genius XL Configuration screen. Make sure to check the Enabled box, then follow the instructions
below:
Select the discovered radio S/N
Location of the radio S/N
Serial Number: The utility program will detect your FLEX‐6000 transceiver(s) automatically. If your radio is
connected to Port A of the tuner, click on the Port A serial number drop‐down list, and select your radio. You
can find your radio's serial number on a sticker on the back panel of the radio or in the Smart SDR Radio Setup
dialog as shown above. If a FLEX‐6000 transceiver is connected to Port B, make the Port B configuration
settings similarly.
It is not required that you connect ANT1 output on a FLEX‐6000 series connect to Port A input on the tuner. Any
FLEX‐6000 antenna output can be connected to any TGXL Port. However, it is required that the configuration
match the physical connections.
TX Antenna: This field configures the tuner to follow frequency changes in the radio on the selected antenna.
The tuning solution for the indicated frequency is automatically switched in. For example, if ANT1 on a FLEX‐
6000 transceiver is connected to tuner Port A input, select ANT1 as the value for the Port A Configuration
section. When ANT1 is selected for transmitting on a slice, the tuner will make the corresponding changes to its
tuning solution. The selected band will appear on the tuner's front panel and the utility screen.
ANT1 is Connected to Port A, LAN PTT
ANT2 is Connected to Port A, LAN PTT
Page 24 of 72
Copyright 2021 FlexRadio. All Rights Reserved.
7 June 2021(FW:0.9.12, Utility: 0.9.12)