Compliance - ADTRAN Total Access 300 Series Installation And Maintenance Manual

NOTE
The Total Access 300 Series SFU ONTs are only intended to be used with the
Corning Systems Model FNI‐NG series outdoor NID housing.

Compliance

!
CAUTION
• Electrostatic Discharge (ESD) can damage electronic modules. When
handling modules, wear an antistatic discharge wrist strap to prevent
damage to electronic components. Place modules in antistatic packing
material when transporting or storing. When working on modules, always
place them on an approved antistatic mat that is electrically grounded.
• The Total Access 300 Series SFU ONTs are NRTL Listed to the applicable
UL safety standards. The Total Access 300 Series SFU ONTs meet or exceed
all the applicable requirements of Telcordia GR‐63‐CORE.
• The Total Access 300 Series SFU ONTs are intended for deployment in the
Outside Plant (OSP) at locations where the NEC applies (for example,
Customer Premises) and is intended to be installed by trained service
personnel.
NOTE
Power supply input and output conductors of equipment which are outside
of the building, are intended to be less that 100 feet and have adequate
clearance from power and lightning conductors in accordance with NEC 725
and 800. Final acceptance of the Listed equipment installation will ultimately
be up to the local Authority Having Jurisdiction (AHJ).
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1.This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate this equipment.
Table
6418770XGX-5B
undesired operation.
5 on page 6 shows the Configuration Codes for the GigE SFU ONT.
C A U T I O N C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.

Compliance

5