Electronics Module; Figure 4.Electronics Module - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 GigE SFU ONT Installation and Maintenance Guide

Electronics Module

The Electronics Module (see Figure 4) is designed for insertion into the Outer Enclosure for
use in outdoor applications. The Electronics Module may already be installed in the housing.
Installation and removal can be accomplished by gently pulling the module from the hinge
points on the housing.
Hinge Points
10
NETWORK STATUS
POTS 1
POTS 2
TELEPHONE TROUBLESHOOTING
1. Identify the bad line.
2. Disconnect the plug from the appropriate POTS jack and plug
any working telephone into that jack.
If the telephone works, there is a problem inside the house.
If the telephone does not work, contact your service provider.
3. Remove the telephone and replace the plug into the POTS jack.
4. Close the unit.
Figure 4. Electronics Module
TIP RING
POTS 1
POTS 2
TIP RING
TIP RING
ETH 1
ETH 2
TOTAL ACCESS 352 ONT
1187702G1
CLEI
TEL. NUMBER
12V , 1A
6418770XGX-5B