Indicator Lamp In The Charging Station; Symptoms - Husqvarna AUTOMOWER 310 Operator's Manual

6.4 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Solid green light
Good signals
Green flashing light The signals are good and
vated.
Blue flashing light
The boundary loop is not connected to the
charging station.
Break in the boundary loop.
Red flashing light
Interruption in the charging station's antenna. Contact your local Husqvarna representative.
Solid red light
Fault in the circuit board or incorrect power
supply in the charging station. The fault
should be rectified by an authorized service
technician.

6.5 Symptoms

If your robotic lawnmower does not work as expected, follow the symptoms guide below.
There is a FAQ (Frequently Asked Questions) on www.husqvarna.com which provides more detailed answers to a
number of standard questions. Contact your local Husqvarna representative if you still cannot find the reason for the
fault.
Symptoms Cause
The robotic lawnmow- The boundary wire is not laid in a long
er has difficulty dock- straight line that is far enough out from the
ing. charging station.
The guide wire is not inserted in the slot un-
der the charging station.
The charging station is on a slope.
The robotic lawnmow- The robotic lawnmower clock needs to be set. Set the clock. See
er runs at the wrong
The start and stop times for mowing are in-
time
correct.
The robotic lawnmow- Damaged blades lead to imbalance in the
er vibrates. cutting system.
Too many blades in the same position lead to
imbalance in the cutting system.
Different versions (thickness) of Husqvarna
blades are used.
52 - Troubleshooting
Action
No action required
ECO mode is acti- No action required. For more information on
ECO mode , see Settings on page 32 .
Check that the boundary wire connectors are
fitted properly to the charging station. See
Connecting the boundary wire on page 17 .
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Contact your local Husqvarna representative.
Action
Check that the charging station has been in-
stalled according to the instructions in
ling and connecting the charging station on
page 12
It is absolutely critical for operation that the
guide wire is perfectly straight and is in the
correct position under the charging station.
Therefore make sure that the guide wire is al-
ways in its slot in the charging station. See
Laying and connecting the guide wire on
page 18 .
Place the charging station on a surface that is
entirely level. See
tion on page 10 .
Reset the start time and stop time settings for
mowing. See
Inspect the blades and screws and replace
them if necessary. See
on page 47 .
Check that only one blade is fitted at each
screw.
Check if the blades are of different versions.
Best charging station loca-
Time & Date on page 34 .
Timer on page 24 .
To replace the blades
840 - 001 -
Instal-