Transportation, Storage And Disposal; Transportation; Storage; Disposal - Husqvarna AUTOMOWER 310 Operator's Manual

7.1 Transportation

The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package and labels
for commercial transportations, including by third
parties and forwarding agents.

7.2 Storage

• Fully charge the product. Refer to
battery on page 12 .
• Disconnect the product with the main switch. Refer
Main switch on page 43 .
to
• Clean the product. Refer to
lawnmower on page 46 .
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level ground
during storage, or use a Husqvarna wall hanger.
• If you keep the charging station indoors, disconnect
and remove the power supply and all the connectors
from the charging station. Put the end of each
connector wire in a container with grease.
• If you keep the charging station outdoors, do not
disconnect the power supply and the connectors.

7.3 Disposal

• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the battery, refer
to Removal of battery for recycling on page 56 .
7.3.1 Removal of battery for recycling
Follow these steps for removal of the battery from the
robotic lawnmower.
1. Set the Main switch in position
2. Clean the area around the grommet for the charging
cable found at the very front under the mower.
3. Pull out the rubber grommet on the charging cable
and carefully loosen the connector.
4. The body is fitted to the chassis using 4 quick-
mounted, snap-on brackets. Loosen the body from
the chassis by lifting the body one corner at a time

56 - Transportation, storage and disposal

7 Transportation, storage and disposal
Charging the
Clean the robotic
0 .
while holding the chassis in place.
5. Loosen all 14 screws (Torx 20).
6. Remove the guarantee seal at the point of
separation between the chassis halves on the right-
hand side.
7. Carefully lift the rear edge of the upper section of the
chassis.
8. Disconnect the MMI cable from the main circuit
board and remove the upper section of the chassis.
9. Loosen the 3 screws (Torx 20) holding the battery
cover in place.
10. Disconnect the battery connection from the main
circuit board. Open the battery cover and remove
the battery.
840 - 001 -