Table of Contents
Advertisement
CopperLink Model CL1300MDE User Manual
Introduction
CAUTION
To install the CL1300MDE Ethernet Extender, do the following:
1. If you will be configuring the CL1300MDE DIP switches, see section
erwise, go to step 2.
CAUTION
2. Install the Ethernet extender where it will be used
3. Connect a cable to the CopperLink Line interface (see section
faces"
on page 23)
4. Connect Ethernet cables to the Ethernet interfaces (see section
Interfaces"
on page 26)
5. Connect the power supply cable to the power port (see section
Configuring DIP Switch S2
The DIP switches are located inside the device. They enable you to configure the TCPAM/Rate preset. These
settings are applied when the device powers on, and they cannot be changed while the device is powered on.
Keep this in mind if you plan on adjusting these settings later remotely, as the DIP switch settings at boot will
always take priority.
1. Using a small cross-tip screwdriver, remove the protective cover located on the right side panel of the
CL1200E (see
figure 3
Introduction
The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
If you will be configuring the device using the DIP switches, do
so before powering up the device
on page 20).
"Configuring DIP Switch
("Installing the device"
"Connecting the CopperLink Line Inter-
"Connecting the 10/100Base-T Ethernet
"Connecting Power"
2 • Installation
S2". Oth-
on page 21)
on page 26)
19
Advertisement
Table of Contents
