Software; General Information About Software; Software Products - Mitsubishi Electric E1000 Series Service And Maintenance Manual

4

Software

This chapter describes how to maintain and update the software in the E1000
operator panels. The chapter includes a general description of the operator panel soft-
ware and instructions about how to upgrade the software and load projects and sys-
tem programs.
4.1

General Information about Software

The software required to run and maintain the operator panels is found on the soft-
ware CD. It is also available through your local distributor.
The software is tested by the manufacturer's own testing department before market
introduction is approved. The test procedure is closely integrated with the develop-
ment process. The test group works in close concert with the developers and is ISEB
Certified for Software Testing.
4.1.1

Software Products

The following software products are used:
– E-Designer 7
E-Designer 7 is used for creating application projects for E1000 operator panels and
their accessories.
– Remote Access Viewer
Remote Access Viewer is a program for remote access and control of E1000 operator
panels.
It is possible to access, reflect and control an E1000 operator panel from a PC using
the VNC client program Remote Access Viewer (freeware) together with the built-in
VNC server (Remote Access function) in the operator panel.
– System Program
The operator panel is delivered with a system program (operating system)pre-stored
in the operator panel memory.
The configuration tool E-Designer 7 is used to download system programs to the op-
erator panel.
– Image Loader
The firmware (the software in the operator panel) for E1032, E1041, E1043, E1060,
E1061, E1062, E1063, E1071, E1070, E1100, E1101 and E1151 consist of three
parts at delivery:
1. E-Boot, the program that starts up the operator panel and Windows CE.
2. Windows CE .net 4.20, the operating system for the operator panel.
3. OPsys, the system program in the operator panel that contains the HMI func-
tionality.
E1012 and E1022 use the operating system Green Hills Velocity.
E-Designer 7 can be used to update one part of the firmware, the system program
Opsys_b*.cab, to the operator panel.
See the System Program
Mitsubishi Electric, MA00758A
section.
Software
59