Mitsubishi Electric E1000 Series Service And Maintenance Manual page 35

E1101
Follow the steps below to replace the display/display cable of E1101:
1. Power off the operator panel.
2. Follow the instructions under
3. Disconnect the flex cable and the cable to the LED on the power card and
remove the two plastic nuts that keep the power card in place.
4. Lift up the power card and gently remove the backlight cables and the display
cable from the rear side of the power card.
5. Remove the mounting plate (9 torx screws). Gently lift up the mounting plate
and the display.
6. Flip the mounting plate and unscrew the 4 torx screws, see figure below.
7. Make sure the display cable is attached to the new display before reattaching the
mounting plate.
8. Re-assemble the complete operator panel.
Mitsubishi Electric, MA00758A
Replacing the Rear Cover to remove the rear cover.
LED cable
plastic nut
flex cable
plastic nut
display cable
backlight cables
9 x torx screws
4 x torx screws
Hardware
35