Mitsubishi Electric E1000 Series Service And Maintenance Manual page 31

E1071/E1070
To replace the display/display cable you will need a new display including plastic
frame and display cable, see the
Follow the steps below:
1. Power off the operator panel.
2. Follow the instructions under
3. Disconnect the two (E1071) or three (E1070) flex cables from the power card,
according to the illustration below, and remove the two plastic nuts that holds
the power card in place.
Illustration of E1071 showing the two flex cables
Illustration of E1070 showing three flex cables
4. Lift the power card and gently remove the backlight cable from the rear side.
5. Gently loosen the complete plastic frame and display from the front plate.
Scrap the display and frame.
6. Mount the new display/display cable and frame and re-assemble the complete
operator panel. Make sure the guide pins on the frame are properly fastened in
the holes in the front plate.
7. Re-assemble the complete operator panel.
Mitsubishi Electric, MA00758A
Available Spare Parts section.
Replacing the Rear Cover
plastic nut
flex cables
plastic nut
plastic nut
flex cables
plastic nut
guide pins
backlight cable
guide pins
snap-in closure for plastic frame
Hardware
to remove the rear cover.
31