Replacing The Complete Front - Mitsubishi Electric E1000 Series Service And Maintenance Manual

Hardware
3.7.7

Replacing the Complete Front

The following is needed:
– A new front, see the
– A torx T10 screwdriver.
Note:
Make sure you have adequate ESD protection
E1012, E1022, E1032, E1041, E1043, E1060, E1061, E1062 and
E1063
Follow the steps below to replace the complete front of the operator panel:
1. Power off the operator panel.
2. Follow the steps 1-6 in the
the current panel model.
3. Attach the new front.
4. Re-assemble the unit.
E1070 and E1071
Follow the steps below to replace the complete front of E1070/E1071:
1. Power off the operator panel.
2. Follow the steps 1-3 and step 5 in the
instruction for E1070/E1071, but in step 3, do not remove the display cable.
3. Attach the new front.
4. Re-assemble the unit.
E1100
Follow the steps below to replace the complete front of E1100:
1. Power off the operator panel.
2. Follow the steps 1-3 and step 5 in the
instruction for E1100, but in step 3, only disconnect the flex cable (do not
remove the power card).
3. Attach the new front.
4. Re-assemble the unit.
E1101
Follow the steps below to replace the complete front of E1101:
1. Power off the operator panel.
2. Follow the steps 1-3 and 5 in the
for E1101, but in step 3, only disconnect the flex cables and the LED cable (do
not remove the power card).
3. Attach the new front.
4. Re-assemble the unit.
38
Available Spare Parts list.
.
Replacing the Display/Display Cable
Replacing the Display/Display Cable
Replacing the Display/Display Cable
Replacing the Display/Display Cable
instructions for
instruction
Mitsubishi Electric, MA00758A