Mitsubishi Electric E1000 Series Service And Maintenance Manual page 32

Hardware
E1100
Follow the steps below to replace the display/display cable of E1100:
1. Power off the operator panel.
2. Follow the instructions under
3. Disconnect the two flex cables from the power card and remove the two plastic
nuts that keep the power card in place.
4. Lift the power card and gently remove the 2 backlight cables and the display
cable from the rear side of the power card.
5. Remove the mounting plate (9 torx screws). Gently lift the mounting plate with
the display and power card.
6. Flip the mounting plate and unscrew the 4 torx screws.
7. Make sure the display cable is attached to the new display before reattaching the
mounting plate.
8. Re-assemble the complete operator panel.
32
Replacing the Rear Cover to remove the rear cover.
plastic nut
flex cables
plastic nut
9 x torx screws
4 x torx screws
Mitsubishi Electric, MA00758A