Mitsubishi Electric E1000 Series Service And Maintenance Manual page 34

Hardware
E1061/E1063
To replace the display you will need a new display including display frame, see
the Available Spare Parts
Follow the steps below:
1. Power off the operator panel.
2. Follow the instructions under
3. Unlock the two flex cable connectors by pressing the connector flanges towards
the cable and disconnect the flex cables and the plain cable from the power card.
The connectors must be unlocked on both sides before removing the cables.
4. Gently press the power card towards the top of the panel as shown in the illustra-
tion above to release the power card from the power card holders.
Then tilt the bottom of the card away from you.
5. Disconnect the plain cable on the back side of the power card and then remove
the power card.
6. Insert the two screwdrivers between the display frame and the aluminum casing
illustrated below. Press and bend gently on the display frame to unlock the frame
and tilt up the display frame.
7. Mount the new display unit.
8. Re-assemble the complete operator panel.
34
section.
Replacing the Rear Cover
flex cables
plain cable
power card
display frame pressure points
to remove the rear cover.
Mitsubishi Electric, MA00758A