Starting Procedure; Break-In Procedure - GAS GAS ENDURO 4T EC 2014 Owner's Manual

Owner´s manual

Starting procedure

2

Break-in procedure

To start your GAS GAS follow this steps:
1. Open the fuel tap.
2. Deploy the kickstarter.
3. Give the throttle two energic strokes.
4. Pull the choke lever (1).
5. Push the kickstarter vigorously.
NOTE: With the motor at the operating temperature it will be necessary to pull
the choke lever.
1
To start your GAS GAS by electric start follow this steps:
1. Open the fuel tap.
2. Turn on the key (2).
3. Give the throttle two energic strokes.
4. Pull the choke lever (1).
5. Pull the clutch lever.
6. Push the kickstarter vigorously.
NOTE: With the motor at the operating temperature it will be necessary to pull
the choke lever.
It is important to respect the break-in procedure, with this you will ensure the
duration and correct function of your GAS GAS in the long term. Intervals to res-
pect are as follows:
1. From 0 to 200 Km.: Ride between 50% and 75% of load (throttle opening),
alternatively, without continued use of the 75% load.
2. From 200 a 300 Km.: Ride equal but occasionally reaching the 100% load,
without keeping it more than 5~10 seconds.
3. From 300 a 400 Km.: Ride between 75% and 100% of load alternatively,
without keeping the full load.
4. From 400 Km, increase demand with progressivity for about 60~80 Km, to
reach its full performance.
An imprudent acceleration can cause engine problems. Be careful to use the
skills and techniques necessary when driving the bike.
DANGER
-27-