Owner´s manual
Carburetor setting
Correction factor
1,06 o higher
Needle position
Lower clip 1 position
Mixture screw opening
Tighten 1 turn
CORRECTION FACTORS
(For temperature or altitude changes).
Needle position / Mixture screw opening
1,06~1,02
Same
Tighten ½ turn
1.
Find the correction factor to adjust the carburetor.
Example: 1000 m altitude and 35°C temperature, the correction factor is
0.94.
2.
Using the correction factor, select the main jet.
Example: Factor 0.94, multiply the main jet size by this number.
Main jet = 175 x 0.94 = 165.
3.
Find the correction factor for the needle and air screw on the table and
change the clip position and air screw opening.
Example: Raise clip 1 position and loosen 1 turn the mixture screw.
WARNING
To make corrections always take as reference the competition carburetion. Do
not make changes if you are not sure that they are needed. This specifications are
based on the use of the recommended gasoline and oil.
-60-
1,02~0,98
0,98~0,94
Same
Same
Same
Loosen ½ turn
0,94 or lower
Raise clip 1 position
Loosen 1 turn