Measure Of The Wheel Circumference - GAS GAS ENDURO 4T EC 2014 Owner's Manual

Owner´s manual
Multifunction gauge (Only on certain models and markets)
Screen 3: ODP
ODO (odómeter), is the kilometers totality which has been traveled , is the total
sum.
Press and hold buttons 1 and 2 for three seconds to reset the maximum speed.
To see the remaining time until the next maintenance, hold button 3 for 3 se-
conds.
When the service icon is activated, to enter the maintenance time period screen
and then reset the time period of the service, hold buttons 1 and 2 for 3 seconds.
Notes:
1. Activated with external power of the motorcycle.
2. Activated by the movement of the wheel.
3. Activated by pressing the multifunction button itself.
4. The backlight turns off after 90 seconds of inactivity.
5. After 180 seconds of inactivity, it only shows clock.
INSTALLATION OF SENSOR AND MAGNET:
Motorcycles require a magnet placed on a rotating surface, such as the front or
rear wheel, and a sensor in front of the magnet to create a wheel sensor.
If you have purchased a variety of our model that is not approved and want to ins-
tall the multifunction, you must also acquire the approval kit for the front wheel,
which is composed of a plate with a magnet and a small screw that holds the hub
of the motorcycle.

MEASURE OF THE WHEEL CIRCUMFERENCE:

Method 1
Measure the diameter of the front wheel in millimeters. Multiply the diameter by
3.14 and you will get the measure of the wheel circumference.
The diameter in millimeters is the value to be used as the measure for the tire.
Enter this value in the initial setup of your multifunction.
NOTE: If you measure the wheel diameter in inches, first multiply its diameter by
25.4 to convert it into millimeters. Once converted, follow the instructions under
'quick guide' to complete this process.
-23-