GAS GAS ENDURO 4T EC 2014 Owner's Manual page 30

Owner´s manual
Daily inspection
1
Are the brake pads correct? We can visually check the thickness of the lining (1)
that remains, we know if are in function or we must change quickly, the thickness
of the lining must be 1 mm as a minimum.
Does the controls have good touch? Front brake lever, rear brake pedal, clutch
lever, gearbox pedal, starter lever, lights switches, engine stop switch, horn and
lighters switches, gas command, kick starter. All commands have its operation and
characteristic touch, a change indicates an abnormality or damage. You know your
motorcycle, any change that you appreciate will make you immediately go to your
GAS GAS official service. Your GAS GAS official service will be happy to assist you
and ensure your safety.
Does the side stand have a correct touch and function? This is a part of motor-
cycles that often cause problems, including safety problems. Because it is a part
of your motorcycle with have a severe work. If you perceive a strange touch or
difficulty in its retreat, you must clean the lateral stand, its axel and springs, and
verify the tightening of its bolt. If it continues with the incorrect function, go to
your GAS GAS official service immediately, for your safety.
Always check the tires air pressure. If you have pressure problems, go to your
GAS GAS official service.
-30-