General Lubrication; Steering Bearings; Wheel Bearing; Swingarm And Linkage - GAS GAS ENDURO 4T EC 2014 Owner's Manual

Table of Contents

Advertisement

Owner´s manual
Maintenance
1
1
5
4

36.-GENERAL LUBRICATION

2
2
Lubricate the parts shown periodically or when the vehicle is wet, especially af-
ter using high pressure water. Before lubricating each part, clean rusty spots with
rust remover and clean any grease, oil or dirt.
General lubrication
Chain lubrication
3
It is necessary after driving on wet ground when the chain looks dry.
The chain is an o-ring chain, therefore a specific lubricant should be used for
this type of chains. Your GAS GAS official service will be pleasured to provide it.
.

37.-STEERING BEARINGS

For this check, adjustment, or change, you must go to your GAS GAS official
service.

38.-WHEEL BEARING

For this check, adjustment, or change, you must go to your GAS GAS official
service.

39.-SWINGARM AND LINKAGE

For this check, adjustment, or change, you must go to your GAS GAS official
service.

40.-REAR SUSPENSION

Rear shock oil change
For this check, adjustment, or change, you must go to your GAS GAS official
service.
Clutch lever (1).
Front brake lever (2).
Rear brake pedal (3).
Rear brake pedal bearing (4).
Gear shift pedal (5).
Use a spray to lubricate with pressure.
Use grease inside the throttle cable.
-52-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enduro 4t xc 2014

Table of Contents