Piston And Ring; Cylinder Head, Cylinder, Ex. Valve - GAS GAS ENDURO 4T EC 2014 Owner's Manual

Owner´s manual
Maintenance
250/300cc 4T
Engine oil change
The engine oil should be changed periodically to ensure engine life.
1. Heat the engine for 5 minutes, in order to lift all sediments.
2. Stop the engine and put a container under the motorcycle.
3. Remove the emptying screw (see "Checking the oil level") and put the bike
in the use position to allow the complete oil drain.
4. Remove the filler plug (1) to ensure a better draining.
1
5. Remove the oil filter cover (2) and the filter (3).
6. Install the new oil filter and O-ring of the filter cover.
450cc 4T
7. Tighten the filter cover to 10 Nm..
8. Tighten the oil drain plug with washer, tightening to 20 Nm.
9. Take off the filling plug (see "Checking the oil level") and put new trans-
mission oil.
10. Screw the oil filling plug.
11. Check the oil level, after powering the kick-starter for 3 or 4 times.
2 3

8.-PISTON AND RING

For this check, adjustment, or change, you must go to your GAS GAS official
service.

9.-CYLINDER HEAD, CYLINDER, EX. VALVE

For this check, adjustment, or change, you must go to your GAS GAS official
service.
-40-