Troubleshooting Guide - Bertazzoni Professional Series X486GPIRX Use & Care Manual

OVEN PROBLEM
Range does not function
Self‐clean cycle does not activate Door is not shut tight enough for automatic door latch to lock
Broil does not work
Door does not open
Oven light does not work
Igniters does not work
Igniters sparking but no flame
ignition
Igniters spark continuously after
flame ignition
Burner ignites but flame is large,
distorted, or yellow
Oven door is locked and will not
release, even after cooling
Oven is not heating
Oven light is not
properly
Oven light stays on
Cannot remove lens cover on
light
PRE‐HEATING indicator lights up
intermittently and sound alarm
on
HEATING indicator light turned
on intermittently and with sound
alarm on
CLEAN indicator light
intermittently and sound alarm
on
CLEAN indicator light turned on
intermittently, sound alarm off

TROUBLESHOOTING GUIDE

POSSIBLE CAUSES AND/OR REMEDY
Range is not connected to electrical power. Ask a professional to check
power circuit breaker, wiring and fuses.
Temperature control knob is rotated too far past broil position (500°F);
PRE‐HEATING indicator will light intermittently
Oven is still in self‐clean mode. Door latch will release when safe
temperature is reached.
Light bulb is burned out. Range is not connected to power/ clean is cycle
on
Circuit is tripped. Fuse is blown. Range is not connected to power.
Gas supply valve is in "OFF" position. Gas supply is interrupted.
Ignition micro‐switches remain incorrectly engaged; call a qualified
technician for repair.
Burner ports are clogged. Unit is not set to the appropriate gas type. Call
a qualified technician for gas conversion procedure.
Turn the oven off at the circuit breaker and wait 5 minutes. Turn breaker
back on. The oven should reset itself and will be operable.
Check the circuit breaker or fuse box to your house. Make sure there is
proper electrical power to the oven. Make sure the oven temperature
has been selected.
working Replace or reinsert the light bulb if loose or defective.
Check for obstruction in oven door. Check to see if hinge is bent.
There may be soil build‐up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
This is a FAULT alarm indicating the failure of the cooling fan/s. Try
resetting by turning both selectors to the OFF position. If the error is not
repaired, call a qualified technician for diagnosis and repair. If not
repaired, this error indicator will appear again within 10 seconds once
the oven is activated in any functions for which cooling fans are required
to operate, preventing the use of the oven. Set both selectors to OFF
position and call a qualified technician for repair.
This is a FAULT indicating failure of the oven sensor temperature probe;
in this case cooling fans will start automatically. To reset, switch both
selector to the OFF position.
disconnect the appliance from the main electrical supply and call a
qualified technician for repair.
on Electrical power failure happening during cleaning cycle operation;
cleaning cycle interrupted; cooling fans remains both activated; the
error will be reset by putting two selectors in OFF position; repeat
cleaning cycle if needed after 3‐4 hours.
Interruption/Stop of an incomplete cleaning cycle due to a intentional or
accidental displacement of one of the two oven selectors from CLEAN
position during cleaning cycle operation; put both selectors in OFF
To stop buzzer and light indicator,
41