CHAPTER
3
NOTE:
To install the steering kit with an SC1 system, please refer to the CRx/Viper 4+ SC1/TC1 Installation
Manual (P/N 016-8000-014)
To install the steering kit with an RS1 system, please refer to the CRx/Viper 4+ RS1 Installation Manual
(P/N 016-8000-028)
POWER HARNESS
BEST MOUNTING PRACTICES
Ensure the installer follows all of the following guidelines for best mounting practices:
•
Mount the relays in a fixed position and in a dry, clean, and accessible spot.
•
The red wire is positive (12V).
•
The black wire is ground.
•
Ensure wires cannot be damaged during operation.
•
If a ground switch is used, connect the wiring harness behind the ground switch.
•
If a main (12V) switch is used, connect the wiring harness behind the main switch.
•
If no main switch is used, always connect the wiring harness directly to the battery.
•
If the system is connected to a 24V machine, always use a 24V to 12V connector.
•
Lead the terminal harness along with the GPS and radio/GSM antenna cables through on pillar of
the cab.
•
Tie-wrap the wires so they are attached free from vibration and friction.
Installation: Power Harness
I NSTALLATION
C H A P T E R 3
9