Section 09: Clinical Setup For Postural Management - Leckey Squiggles Stander User Manual

8.10 FLAT HEADREST
LATERALS
To attach the headrest lateral covers,
simply slide the covers on with the
padded side towards the inside of the
stander. Then bring the two Velcro
fastener straps around the bottom of the
moulding and attach them to the Velcro
panel as shown. Close over the flap.
SECTION 09:
CLINICAL SETUP FOR
POSTURAL MANAGEMENT
The clinical setup of the product should
be completed by a technically and
clinically competent person who has
been trained in the use of the product.
Leckey recommend a written record is
maintained of all clinical setups for this
product.
Squiggles Stander User Manual p15
9.1 SETTING THE CHEST
SUPPORT HEIGHT
Set the chest support height first by
placing the child in a lying position on
a mat. Measure the distance from the
child's feet to just under their axilla. The
height between the top of the chest
support and the footplate should be set
to this distance.
Never attempt to adjust the
height of the main frame
when the stander is in use.
9.2 ADJUSTING THE
OVERALL HEIGHT
The overall height of the standing
support can be adjusted by loosening the
bolt on the back of the main frame with
the multi-tool. Sliding the inner stem to
the desired height and retightening the
allen bolt. A calibration strip is fitted on
the side of the inner frame to help you
record the selected positions of the
supports. There is also a safety stop at
the maximum height.