Care And Cleaning; Calibration Seal Installation - Cardinal 204 Operation Manual

1. DO NOT submerge indicator in water, pour or spray water directly on indicator.
2. DO NOT use acetone, thinner or other volatile solvents for cleaning.
3. DO NOT expose equipment to temperature extremes.
4. DO NOT place equipment in front of heating/cooling vents.
5. DO clean the indicator with a damp soft cloth and mild non-abrasive detergent.
6. DO remove power before cleaning with a damp cloth.
7. DO provide clean AC power and adequate protection against lightning damage.
8. DO keep the surroundings clear to provide clean and adequate air circulation.

CALIBRATION SEAL INSTALLATION

If your Model 204 Weight Indicator is used in a commercial application it must be tested and
sealed by your local weights and measurement official. The 204 is designed to accept a lead
and wire security seal to prevent unauthorized access to the calibration adjustments. Refer to
the Figure No. 9 for details on the installation of the seal.
Right End Cap

CARE AND CLEANING

(Indicator as viewed from rear)
Figure No. 9
18
Left End Cap