Section 2: Installation; Installing The Changer - Coinco 800 Series Operation And Service Manual

SECTION 2: INSTALLATION

Installing The Changer

1. Remove power from the vending machine.
2. Remove the acceptor from the changer by
releasing acceptor latch and rotating the top
of the acceptor forward, away from changer
(see Figures 1 and 2). Unplug ribbon cable
from changer. Free acceptor studs from
changer housing. Place the acceptor in a
clean area.
3. With the acceptor removed, set the
mounting holes in the back of the changer
housing over the mounting screws in the
vending machine. Tighten securely (see
Figure 3). Do not over tighten as this could
damage the changer housing.
4. Replace the acceptor by inserting bottom
acceptor studs into changer housing guides.
Plug the ribbon cable into the changer (see
Figure 2).
Figure 1
800 Series
Figure 2
5. On units that use a DEX/UCS Hand-held
Computer, attach DEX Plug Ground
Connector to the vending machine frame.
6. Connect the appropriate interface harness to
the vending machine. See typical setup
examples for the protocol being used:
Figure 5 for MDB
Figure 6 for Protocol 'A' (Executive)
Figure 7 for Protocol 'A' (Executive) with
MDB master.
Figure 8 for 4-Price Electromechanical
7. Set the desired vend price and options on
the changer. Refer to Section 3:
Configuration
Note: The vend prices are set on the
vending machine controller when operating
in MDB mode or Protocol 'A' non-price
holding.
Page 5