Removing/Replacing Individual Modules; Clearing Coin Jams - Coinco 800 Series Operation And Service Manual

SECTION 4: MAINTENANCE
Removing/Replacing
Individual Modules
Modular assembly replacement provides the
basis of all COINCO GLOBAL2
changer repair. Instructions for removing and
replacing
modules are provided below. These modules
should be removed in the following sequence:
ACCEPTOR
To remove the acceptor from the changer,
release the acceptor latch and pull the top of the
acceptor forward, away from the changer.
Unplug ribbon cable from changer. Free lower
acceptor studs from changer housing.
UPPER TUBE SENSE BOARD
Remove the grey, smoked front cover by pulling
out on the left side of the cover at the notch in
the housing. The front cover will swing forward,
exposing the tubes. Remove the four inventory
tubes one at a time by pulling upward. Remove
strain relief bracket, which is located in the
upper left corner of changer housing, by remov-
ing screw. Remove recessed screw that secures
logic board cover and remove cover. Push snap
toward top of housing and remove upper tube
sense board (which will separate from main
logic board upon removal).
PAYOUT BASE
Disconnect the two motor harnesses and the
tube sense harness. Remove the screws from the
bottom, exterior sides of the changer housing
and remove payout base.
MAIN LOGIC BOARD ASSEMBLY
Unplug harnesses from logic board and lift the
logic board out of the housing.
Page 26

Clearing Coin Jams

Should a coin jam occur in the cashbox chute
area, use the following steps to help dislodge
coins:
®
series
1. Remove changer from vendor.
2. Keeping changer in an upright position,
3. Remove any lodged coins.
4. Replace the cashbox chute by pressing in
remove cashbox chute (located on the back
of the changer) by pulling lower edge out
and down at the same time.
and up to snap into place.
800 Series