Section 5: Troubleshooting Error Codes - Coinco 800 Series Operation And Service Manual

SECTION 5: TROUBLESHOOTING
Error Codes
If any of the errors listed below as "E001-E007"
are detected the message "Eror" will flash on
the display. To view the error or a list of errors
enter the Display Mode (see "Display Mode"
section of this manual). If a single error is
detected the code will be displayed in place of
the "Full/Fill AbCd" message. If there is more
than one error, the codes will alternate one after
the other.
"FULL/FILL AbCd"........................ No Errors
"E001" ......................Validation Sensors Error
"E002" .............................. Tube Sensors Error
"E003" ....................................... Coin Jammed
"E004" ......................................... Payout Error
"E005" ........................................... ROM Error
"E006" ............................. Configuration Error
"E007" ........................... Supply Voltage Error
The error codes listed below are displayed upon
occurrence:
"E 20" ...................................... Double Arrival
................................... (coins dropped too fast)
"E 88" .............A Payout sweeper arm is at the
.......... end of stroke, re-align the sweeper arm.
"E 82" .................. VMC attempting to pay out
.................................coins from an empty tube
The following errors will require the changer to
be sent to a Coinco service centre for repair:
"E 21" ........................A to D Conversion fault
"E 22" ........................... Validation Opto Fault
................... or jammed coin in validation path
"E 25" & "E 26" ........ EC coil reading timeout
"E 27" & "E 28" ....... MF coil reading timeout
"E 29" ....................... Stored air values corrupt
"E 40" ....................................TAU coil failure
"E 41" ....................................... EC coil failure
"E 42" ...................................... MF coil failure
"E 90" ...................... Acceptor memory failure
800 Series
Page 27