Setting The Vend Price On A Four-Price Changer - Coinco 800 Series Operation And Service Manual

SECTION 3: CONFIGURATION
Setting The Vend Price On
A Four-Price Changer
The vend price on a four-price changer may be
set in four ways:
• via Coinco Support Software;
• via DEX/UCS;
• via the first eight Option Switches;
• via the digital display.
The vend price can be set in single increments
up to 255 times the lowest denomination coin
that is accepted by the changer and routed to a
coin tube.
EXAMPLE: If the lowest denomination coin is
one, the highest vend price setting would be 255
x 1 or 255.
VIA COINCO SUPPORT SOFTWARE
Consult Coinco Support Software manual for
price setting instructions.
VIA DEX/UCS
Consult Hand-held Computer manufacturer.
VIA OPTION SWITCHES
Note: The swiches are ON in the upwards
position.
1. To set the vend price of a selection, add the
value of the rocker switches that are
switched to the ON position (see Figure 11).
2. Set Option Switch B to the ON position.
3. Set Option Switches A, C and D to the
desired configuration (see "Option Switch
Module" section of this manual).
4. After setting the desired vend price on the
Option Switch Module, press and release the
Mode Button (see Figure 2). The changer's
Main Logic Board LED and the "Use Cor-
rect Change" light will begin to flash.
Page 12
5. Within 30 seconds, press and release any one
desired product selection switch on the front
of the machine. The present price on the
switch module is now set for all selections
on that price line and the LED and "Use
Correct Change" light will stop flashing.
6. Repeat the above steps until the remaining
three price lines have been assigned a vend
price.
EXAMPLE: If the first, fourth and fifth price
setting switches are in the UP position, the vend
price setting would be 25 x 1 or 25 (assuming
the lowest denomination coin accepted is 1).
NOTE: If the price for one or more of the
selections is set to zero, that selection is a free
vend.
VIA DIGITAL DISPLAY
1. Enter the Display Mode (see "Display
Mode" section of this manual).
2. Press B to scroll up to C001 (Price 1).
3. Press C to enter. The current price setting is
displayed.
4. Use buttons B (increase) and D (decrease) to
change C001 to the appropriate price.
5. Press A to set the price and return to the
Display Mode.
6. Press B to increase to the next priceline -
E.g. Address C002 (Priceline 2).
7. Repeat steps 3-6 for the remaining three
prices.
8. Once all four prices have been set, press A
twice to exit the Display Mode.
800 Series