Convert A Appliance Model 199 From Natural Gas To Propane Gas Or Viceversa - RBI Infinite Energy2 IW199 Installation And Operation Instructions Manual

13 - INSTALLATION - Gas supply
M
020010.01.020
A
H
Figure 13-3 - Dismantle the
gas valve
L C
B
Figure 13-4 - Lift the gas valve
13.6 - Convert a
appliance model 199
from Natural Gas
to Propane gas or
viceversa
WARNING!!!
conversion shall be performed
by a qualified service agency
in accordance with this
instructions and all applicable
codes and requirements of the
authority having jurisdiction. The
information in these instructions
must be followed to minimize
the risk of fire or explosion or
to prevent property damage,
personal injury or death. The
qualified service agency is
responsible for the proper
conversion of the appliance.
The installation is not proper
and complete until the operation
of the converted appliance is
checked as specified in this
instructions.
020022.01.008
020010.01.021
The gas
NO
YES
85
WARNING!!!
The
conversion shall be carried
out in accordance with the
requirements of the provincial
authorities having jurisdition
and in accordance with the
requirements of the CAN-B149.1
and CAN1-B149.2 installation
code.
Contents:
The conversion kit (supplied with the
appliance) is composed of the following
elements, which are necessary for the
gas change:
- a label rating stating the new gas
setting;
- an instruction sheet;
- an orifice per each burner present on
the unit.
Installing:
in order to make the gas change follow
the instructions below:
1.- Turn off the power to the appliance;
2.- Close the manual gas shut off valve;
3.- Dismantle the jacket of the
appliance, follow Section 16.2;
4.- Unscrew nut "H" as per Figure 13-3;
5.- With the help of a screwdriver,
remove spring "A" (see Figure 13-3);
6.- Remove the gas valve from its site
"C" as per Figure 13-4 (take care
attention to o-ring "L" of Figure 13-4);
7.- Replace orifice "G" of Figure 13-5,
for the correct one for type of gas
used. Verify that the stamping on the
orifice matches the Figure 13-7;
8.- Reinstall the gas valve, paying close
attention to the o-ring "L" of Figure
13-4 and to the gasket between gas
valve and nut "H" of Figure 13-3;
9.- Insert again the spring "A" of Figure
13-3;
10.- Tight nut "H" of Figure 13-3;
11.- Open the manual gas shut off valve;
12.- Check for any gas leaks on nut "H"
of Figure 13-3;