Troubleshooting Table - Hanseatic HWMB814B User Manual

Troubleshooting table

Malfunctions can occur in all electrical appliances. This does not necessarily mean
there is a defect in the appliance. For this reason, please check the tables to see if you
can correct the malfunction.
WARNING!
Risk of electric shock!
Never try to repair an appliance which is defective or presumed to be defective. You
■
can put your own and future users' lives in danger. Only authorised specialists are
allowed to carry out this repair work.
Problem
Wash result is unsatis-
factory/poor
Too much foam is cre-
ated during the wash
cycle
Fabric softener/fab-
ric-care product was
not dispensed
Laundry is discoloured Laundry was washed at too high a
Wash result is not satisfactory
Possible causes
The water is too hard or there is not
enough detergent
Too much laundry in the drum
Selected cycle is not right for the
level of dirtiness of the laundry
Water temperature too low
Stains were not pretreated
Too much detergent used
The detergent is not suitable for the
washing machine
Insert in fabric softener/starch com-
partment was not installed properly
or is clogged
temperature
Coloured laundry items were add-
ed to the wash
Troubleshooting table
Solutions, tips
Use the amount of detergent rec-
ommended by the manufactur-
er for the water hardness in your
area.
Only load the drum with the maxi-
mum amount of laundry intended.
Select another wash cycle or
adjust the level of soiling (see
page EN-15 and page EN-19).
Wash laundry at a higher water
temperature, select another wash
cycle or increase the water tem-
perature (see page EN-15 and
page EN-19).
Treat stains with ox-gall soap or
stain remover if necessary.
Next time, use less detergent.
Use a detergent that is suitable for
the washing machine.
Remove insert and install it again
properly; clean if necessary (see
page EN-27).
Bleach laundry carefully if neces-
sary.
Sort laundry before washing (see
page EN-22).
Page EN-35