Installing Washing Machine; Aligning The Washing Machine - Hanseatic HWMB814B User Manual

2. Remove the transport safety devices and
keep them safe so that you can use them
for another transportation.
(c)
3. Close off the transport safety holes with
the enclosed covers (c).
4. Keep the transport safety devices in a
safe place. Reinstall the transport safe-
ty devices every time the appliance is
moved – when moving home or returning
the appliance!
Installing the transport safety
devices
• Reinsert the transport safety devices (15)
before moving the washing machine
every time. For this purpose, follow the
steps described above in the reverse se-
quence.
Set-up and connection

Installing washing machine

The installation site must fulfil the following
requirements:
– The installation site must be frost-proof.
– There must be a water supply and drain as
well as a power socket nearby.
– Even after setting up the appliance, the
mains plug must be easily accessible.
– The ground must be secure, even, clean
and dry.
– The appliance must not be positioned di-
rectly on a rug or carpet as it will then not
be adequately ventilated and can overheat.
Where rugs, carpet, parquet or wood-
en floorboards are present, place a sta-
ble wooden plate measuring at least
60 × 60 cm underneath the appliance.
– When positioning on a wooden plate or
base, these must be equipped with in-
dentations for the screw-on feet so that
the appliance does not migrate off it when
spinning.
– For smooth tiled floors, lay a rubber mat
under the screw-on feet.

Aligning the washing machine

1. Loosen the lock nut of one of the screw-
on feet underneath the appliance.
2. Manually screw or unscrew each foot until
the washing machine is level.
3. Twist the lock nuts (39) of all screw-on
feet upwards to the underside of the ap-
pliance and tighten the lock nuts against
the underside of the appliance.
Page EN-31
(39)