Ducati SUPERBIKE 848 EVO Owner's Manual page 54

To set the rear brake pedal, loosen counter nut (4).
6 7
Turn the pedal travel adjustment screw (5) until the pedal is
E
in the desired position.
Tighten the lock nut (4) to a torque of 2.3 Nm.
Work pedal by hand to make sure it has 1.5 to 2 mm free play
before brake begins to bite.
If not, adjust the length of the master cylinder pushrod as
follows.
Slacken off the lock nut (6) on the pushrod.
Tighten linkage into fork (7) to increase play, or unscrew
linkage to reduce it.
Tighten the lock nut (6) to a torque of 7.5 Nm and re-check
the free play.
4
5
fig. 39
53